How to draw a Slot in AutoCAD By Soft Services Co

website slot dimension in drawing Basic dimensions are usually shown on a drawing enclosed in a box, but they This case is often used to position a slot or profile of a surface slot gacor nexus engine SLOT CENTER MARKS - DRAWING

slot dimension in drawing There are 3 ways to dimension slots or oblongs 1) Long axis of slot, center-center length and outside width, and radii 2) Outside length and  slots), give To avoid confusion and the possibility of error, no dimension should be repeated twice on any sketch or drawing   The two types, the tee slot and the dovetail slot, are shown in Figure 4-5 The drawing shows the dimensions of the threaded part but other information

Share

Share

Link

Turn off sharing Copy link

See all details